[C8] Using Extended Functions (SET UP 8) — EXTEND Menu

Menu 2 Chapter

[C8] EXTEND menu

Enter the password (ENTER PASSWORD [C81]) When the correct password is entered, the following item appears. Choose the function to execute. RE-LOAD FACTORY DATA... : Restore factory

default data for the board installed in the selected slot. ÷[C811]

MEMORY CARD... : Read and write setting and adjustment data by using the monitor memory card. ÷[C812]

RE-START MONITOR: Restart the monitor. ÷[C813]

ADJ INT SIGNAL: Automatically adjust the SETUP level and 100 IRE level of internal signals. ÷[C814]

VDR MODE: Select the mode of the connected VCR. ÷[C815]

MAINTENANCE: Display the menu for maintenance.÷[C816]

[C811] RE-LOAD FACTORY DATA menu Select a slot where a board is installed to reload factory default data to the board.÷[C8111]

[C8111] RE-LOAD FACTORY DATA menu The following message appears to confirm the data reload operation.

DATA RESET TO

ITS FACTORY SETTING

AND MONITOR WILL RESTART

ARE YOU SURE?

OK: ENTER KEY

CANCEL: MENU KEY

OK: To continue, press the ENTER or Ent button.

÷Resets the data and automatically turn the

monitor off and on again.

CANCEL: To cancel, press the MENU button.

÷Returns to the RE-LOAD FACTORY DATA menu. ([C811])

[C812] MEMORY CARD menu

Insert the monitor memory card into the MEMORY CARD slot and select the operation to perform. BACK UP SYSTEM DATA... : Write the data to the

monitor memory card. ÷[C8121] RE-STORE SYSTEM DATA... : Read the data from

the monitor memory card. ÷[C8122]

Notes

•Before using a monitor memory card, it must be formatted it with the FORMAT menu ([D4]).

•System data and MEMORY CARD data ([D]) cannot be stored on the same memory card. To store memory card data, use another memory card.

•The BKM-12Y monitor memory card has a capacity of 256 Kbytes. It can store either system data for up to 8 monitors or 38 files of memory card data.

•The input signal is not displayed during the data saving or loading.

[C8121] BACK UP SYSTEM DATA menu

While the system is writing the data, a “–” mark blinks at the top right of the menu. (It takes some time to save the data.)

BACK UP SYSTEM DATA

IN PROGRESS...SYSTEM

[C8122] RE-STORE SYSTEM DATA menu The following message appears to confirm the data restore operation.

RE-STORE SYSTEM DATA

ALL DATA WILL BE RESTORED

ARE YOU SURE?

OK: ENTER KEY

CANCEL: MENU KEY

OK: To continue, press the ENTER or Ent button.

÷Read the data from the monitor memory card

and automatically turn the monitor off and on again.

CANCEL: To cancel, press the MENU button.

÷Return to the MEMORY CARD menu ([C812]).

[C813] RE-START MONITOR menu

Turn the monitor off and on again automatically.

[C814] ADJ INT SIGNAL menu

Adjust the SETUP level and 100 IRE level of the internal white signal which is used with the COLOR TEMP ADJ menu ([B]).

[C815] VCR MODE menu

Improve the skew of the picture when a non-standard signal is input from the connected VCR. This menu is effective for the 480/60I or 575/50I format signals only. ON: Always activates this function for the 480/60I or

575/60I format signals. OFF: Deactivates this function.

[C816] MAINTENANCE menu

The menu for the maintenance personnel is displayed.

56