[C1] Setting the Input Configuration (SET UP 1)
— INPUT CONFIGURATION Menu
Overview
Data pertaining to the input signals are set with the INPUT CONFIGURATION menu.
When a channel number (1 to 90) is entered with the numeric keypad, it is then possible to set which input connector on the rear panel will be assigned to that channel number, and select the type of signal that will be connected.
The following data can be set with the INPUT CONFIGURATION menu.
•Assigning the signal FORMAT
•Assigning the SLOT NO
•Assigning the INPUT NO (input connector number)
•Selecting the YC SEP (separation) filter
•Selecting the SYNC MODE
•Selecting the SCREEN MODE
•Selecting the SAFE AREA DISPLAY
•Setting the SAVE AREA MODE
•Activating/deactivating the APERTURE adjustment
•Assigning the APERTURE VALUE
•Turning on/off the FILTER operation for monochrome display
•Assigning CHANNEL NAME
•Selecting the picture CONTROL settings
•Setting the COLOR TEMP (temperature)
•Adjusting H PHASE
•Assigning the number of active scanning lines of 1125/60I SYSTEM
•COPYing FROM other data
Note
Data copy is impossible between monitors other than
Channels 91 to 99 assignment
The channel numbers from 91 to 99 are assigned to internal signals.
091:PLUGE signal (Picture Line Up Generating Equipment)
092:20% gray signal
093:100% white signal
094:
095:cross hatch signal
096:cross hatch signal
097:dot signal
098:cross hatch signal
099:0% black signal
Assigning slot and connector numbers
Set which input connector on which slot will be assigned to the current channel. The slots are numbered from the left, as seen when facing the rear panel, with the REMOTE connectors slot being number 1, the input option slots numbers 2 to 5, and the analog input connectors slot being number 6. The connectors for each slot are numbered 1 to 6 (from the top).
Assigning the signal type and format
The signal type and format which can be assigned to each channel number vary, depending on what adaptors (not supplied) are installed in the rear panel.
To assign serial digital signals
Serial digital signals can be assigned to the serial digital input connectors on the
You need to install one of the
To assign analog composite signals Analog composite signals can be assigned to any analog input connectors on the
You need to install one of the following decoder adaptors.
To assign NTSC signals:
To assign PAL signals:
To assign
To assign SECAM signals:
To assign Y/C signals
Y/C signals can be assigned to any input connectors on the
You need to install one of the following decoder adaptors.
To assign NTSC signals:
To assign PAL signals:
To assign
To assign analog component or RGB signals Analog component and RGB signals can be assigned to any input connectors except the serial digital signal input connectors on the
Menu 2 Chapter
35