Menu Function 11 Chapter
Page 1
Item |
| Setting | |
|
|
|
|
F1 (TCG) |
| Selects the time code to use. | |
| INT: Time code generated by the internal time code generator | ||
| EXT: One of the following time codes | ||
|
| • When F6 (TCR) is set to LTC or AUTO, the external time code input from the TIME CODE IN connector | |
|
| • When F6 (TCR) is set to VITC, the VITC time code of the input video signal | |
|
| RP188: Synchronize the internal time code generator with the SMPTE RP188 time code contained in the | |
|
| SDI input signal. | |
|
|
|
|
|
| Note | |
|
| If you set this menu item to RP188 when F1 (VID.IN) in the HOME page is not set to SDI or when no SDI | |
|
| input is present, the menu setting display “RP188” flashes as a warning. Nevertheless, the unit operates in | |
|
| compliance with the setting of this menu item. | |
|
|
|
|
F2 (TCG) |
| For the internal time code generator, selects one of the following. | |
| PRESET: Preset the initial value of time code generated by the internal time code generator by a control | ||
|
| panel operation, or by remote control from the device connected to the | |
| REGEN: Synchronize the internal time code generator with the playback time code read by the internal | ||
|
| time code reader. | |
|
|
|
|
F3 (RUN) |
| Selects one of the following running modes for the internal time code generator. | |
| FREE: The time code continues to increase as long as the unit is powered on, regardless of the unit’s | ||
|
| operating mode. | |
| REC: Time code increases during recording only. If you select this mode, you should also set F1 (TCG) to | ||
|
| INT, and set F2 (TCG) to PRESET. | |
|
|
|
|
F4 (DF) |
| In | |
|
| the CTL counter. | |
| DF: | ||
|
| NDF: | |
|
|
|
|
F5 (VITC) |
| Specifies whether or not to record the VITC generated by the internal time code generator. | |
|
| ON: Record internally generated VITC. | |
|
| OFF: Do not record internally generated VITC. | |
|
|
|
|
F6 (TCR) |
| Selects the type of time code to display in the time data display. | |
| LTC: Display LTC. | ||
| AUTO: Display VITC when tape speed is 1/2 or less of normal speed, and LTC otherwise. | ||
| VITC: Display VITC. | ||
|
|
|
|