Parts of Function and Location 2 Chapter
1POWER switch
2REMOTE buttons and
|
| 3 EJECT button |
|
|
| 4 Format indicators | Cassette compartment |
|
|
| |
|
| BETACAM/SP BETACAM SX MPEG IMX Digital BETACAM |
|
POWER | REMOTE | EJECT |
|
| 1(9P) 2(50P) |
|
Z
PHONES
5PHONES jack and control
1POWER switch
Pressing the ‘ ) ’ side of the switch powers the unit on. When the unit is powered on, the audio setting display section (see page
2REMOTE buttons and
1(9P): This unit is controlled by the device connected to the REMOTE
2(50P): This unit is controlled by the device connected to the REMOTE 2 PARALLEL I/ O(50P) connector. The button lights.
3EJECT button
To eject the cassette, press this button. While the cassette is being ejected, this button lights.
When using the lower control panel as remote control panel, press the DELETE button and STOP button at the same time to eject the cassette.
Note
Ejecting with the EJECT button is a local operation. It is not possible to eject a cassette in another unit by remote control.
4Format indicators
The BETACAM/SP, BETACAM SX, MPEG IMX, or Digital BETACAM indicator1) lights depending on the current recording or playback format.
The BETACAM/SP indicator lights when the format is Betacam or Betacam SP.
5PHONES jack and control
Connect stereo headphones with an impedance of 8 ohms, to monitor the sound during recording, playback and editing.
The control knob adjusts the volume.
It is possible to set an internal board switch so that the output volume from the MONITOR OUTPUT L and R connectors is controlled simultaneously.
For details, refer to the Installation Manual.
..........................................................................................................................................................................................................
1)The BETACAM/SP, BETACAM SX, and MPEG IMX indicators do not exist on the
Chapter 2 Location and Function of Parts |