6-3 Shot Mark Operations
This section describes the operations concerning reading and writing shot marks. Note that the following operations cannot be carried out by remote control.
To read in shot marks
With a cassette loaded, hold down the LIST button and press the F FWD or REW button.
Z
F FWD button
REW button
LIST button
While the shot marks are being read in, the F FWD or REW button flashes.
The unit searches to the end of the tape, then rewinds automatically.
For the procedure for listing the shot marks read in, see page
Note
It is only possible to read in a maximum of 200 shot marks.
When 200 shot marks have been read in, the control panel display shows the message
To cancel the message, press one of the tape transport buttons.
To stop reading
Press the STOP button.
Reading shot marks from more than one cassette
After changing the cassettes, carry out the reading operation again.
Data written in the new cassette will be added as long as the total does not exceed 200 shot marks. For example, if 190 shot marks have already read in, only 10 shot marks will be read from the new tape.
In the shot mark list (see page
Writing recording start marks during recording
In item G03 of the shot mark operation menu (page
When you set a particular mode to “ON”, a recording start mark is written on the tape each time you start recording in that mode.
Note
For insert mode, press the TC button to turn the indicator on.
Writing shot mark 1, shot mark 2, or post marks
Selecting the type of shot mark written
In item G04 of the shot mark operation menu (page
Note
If any of the settings (to write a recording start mark) in item G03 of the shot mark operation menu are set to “ON,” then for 20 frames from each recording, assemble editing, or insert editing start, the user bits are overwritten with the shot mark data.
Function Mark Shot 6 Chapter
Chapter 6 Shot Mark Function |