Menu items in the range 800 to 899, relating to audio control (Continued)
Item number | Item name | Settings | ||||
|
|
|
|
|
|
|
807 | AUDIO OUTPUT PHASE | Select the output timing of digital audio playback signals: (SDI and AES/EBU | ||||
|
| only). The reference position corresponds to a setting of 80H; when the setting is | ||||
|
| less than 80H, the output timing is advanced, and when it is higher than 80H, | ||||
|
| the output timing is delayed. (at 80H, 128 samples = approx. 2.7 ms, and 1 | ||||
|
| sample=approx. 20 µs) | ||||
|
| 0 ... 80 ... FF : Setting in this range | ||||
|
|
|
|
|
|
|
808 | INTERNAL AUDIO | Select the operation of the internal audio test signal generator. | ||||
| SIGNAL GENERATOR | OFF | : No operation | |||
|
| SILNC: Silent signal | ||||
|
| 1KHZ: At 1 kHz, | ||||
|
| To turn on the internal audio test signal generator, set this menu item to other | ||||
|
| than OFF, then hold the audio signal selection button for CH1 (channel 1) for | ||||
|
| three seconds or more. When the test signal generator is turned on, the input | ||||
|
| signal indicator in the audio setting display section turns off. To turn off the test | ||||
|
| signal generator, press the audio signal selection button for any of CH1 to CH4 | ||||
|
| (channels 1 to 4). | ||||
|
|
|
|
|
|
|
809 | AUDIO LEVEL METER | Set the brightness of the audio level meters. | ||||
| DIMMER CONTROL | 0 ... 7: Set in this range. 0 is the brightest, and 7 the dimmest. | ||||
|
|
|
|
|
|
|
810 | AUDIO EDIT PREVIEW | Set the output phase for the audio playback signal when any of the ASSEMBLE, | ||||
| SWITCHER | VIDEO, AUDIO CH1 to CH4, CUE, and TC buttons is lit. | ||||
|
| INT | : The audio playback signal output phase is the same as the output phase in | |||
|
| the | ||||
|
| previewing while watching the VTR output signal. | ||||
|
| EXT: The audio playback signal output phase is the same as the phase of an | ||||
|
| input video signal or external reference video signal. | ||||
|
|
|
|
|
|
|
|
| Note | ||||
|
| Whichever setting is used, the correct editing results will be obtained. When, | ||||
|
| however, you are using an external switcher to switch the audio output signal | ||||
|
| from this unit for the purposes of preview, selecting EXT will prevent any muting | ||||
|
| or discontinuities in the audio at editing IN and OUT points. | ||||
|
|
|
|
|
|
|
815 | AUDIO SAMPLING RATE | Select the mode of operation of the sampling rate converter for AES/EBU input to | ||||
| CONVERTER | channels 1 to 4. | ||||
|
| OFF |
| : No operation | ||
|
| 44kHz: Operate. Choose this setting when the input signal sampling frequency is | ||||
|
| 44 to 48 kHz. | ||||
|
| 32kHz: Operate. Choose this setting when the input signal sampling frequency is | ||||
|
| 32 kHz. | ||||
|
|
|
|
|
|
|
|
|
|
|
|
| (Continued) |
Menus Setup 12 Chapter
Chapter 12 Setup Menus