Parts of Function and Location 2 Chapter

2-1 Control Panels

2-1-3 Switch Panel

To access the switch panel, open the lower control panel. On how to open the lower control panel, see the figure on page 2-1.

CONTROL PANEL

KEY INHI

PANEL SEL

ON OFF REAR FRONT

4 CONTROL PANEL connector

3 PANEL SELECT switch

2KEY INHIBIT switch

1Memory stick slot

1Memory stick slot

Use this to update the firmware. You can also save or load setup menu settings onto the Memory Stick.

Note

After inserting a Memory Stick, allow at least five seconds to elapse before removing it.

For details on firmware update and save or load setup menu settings, see Section 13-1 “Overview of Setup Utility Menu Functions” and refer to the Maintenance Manual Volume 1.

2KEY INHIBIT switch

Moving this switch to the ON position disables the controls on the upper and lower control panels.

You can specify which buttons and knobs are disabled in setup menu item 118.

3PANEL SELECT switch

In addition to the lower control panel, you can connect a similar control panel to this unit. When two control panels are connected to the unit, the PANEL SELECT switch is used to specify which panel be enabled to control the unit.

FRONT: Enables the control panel connected to the CONTROL PANEL connector on the switch panel.

REAR: Enables the control panel connected to the CONTROL PANEL connector on the connector panel. When setup menu item 117 is set to PARA, this switch position also enables the control panel connected to the CONTROL PANEL connector on the switch panel.

4CONTROL PANEL connector (10-pin, round type)

Plug in the lower control panel connection cable.

2-14

Chapter 2 Location and Function of Parts