To add and delete clips
To add clips
1Rotate the MULTI CONTROL knob to move the “*” cursor to the position where you want to insert the clip.
2Press the F2 (SELECT) button.
The unit enters clip data modification mode.
3Press the F5 (INS LN) button.
A confirmation message “INSERT CLIP OK?” appears.
4Press the F2 (OK) button.
The clip is added at the position to which you moved the cursor in step 1.
To delete clips
1Select the clip to delete.
2Press the F2 (SELECT) button.
The unit enters clip data modification mode.
3Press the F4 (DEL LN) button.
A confirmation message “DELETE THIS CLIP OK?” appears.
4Press the F2 (OK) button.
The clip selected in step 1 is deleted.
To set time code data
Proceed as follows to make or change settings for cue point, IN point, and OUT point data.
1Select a clip.
2Select cue point, IN point, or OUT point.
3Press the F2 (SELECT) button.
The unit enters clip data modification mode.
4Press the F2 (MODIFY) button.
The two most significant digits begin to flash, and the data can be set or modified.
5Press the F3 (T) or F4 (t) button until the digit that you want to set starts flashing.
6Rotate the MULTI CONTROL knob to make the setting.
To display the offset from the previous setting value
The offset is displayed as long as you hold down the F2 (OFFSET) button.
7Repeat steps 5 and 6 until you have set all the required digits.
8Press the F5 (SET) button.
The setting is confirmed and the unit returns to clip data display mode.
To cancel the setting or modification and return to clip data display mode
Press the F1 (CANCEL) button.