Sony PDW-1500 manual 142

Troubleshooting and Maintenance 9 Chapter

Message in time	Display	Description	Action
data display	condition a)
REC-PAUSE!	on	A time code or user bits preset	Try the operation again after stopping
		command was received with recording	recording.
		paused.
REC mode!	on, limit	A command to switch video or audio
		signals was received during recording.
REC mode!	on, limit	A command to switch audio channels
		was received during recording.
a) With respect to setting of basic menu item 016

During recording and editing operations

Message in time	Display	Description	Action
data display	condition a)
Disc Error!	on, limit, off	Normal recording is not possible	Use another disc.
		because of a disc defect.	You can check the state of a disc by
			checking playback condition marks (see
			page 44).
525/60 sig!	on, limit	A 525 system SDI signal was input with	Input a 625 system SDI signal.
		this unit in 625 line mode (PAL system)
		and with “SDI” selected with the VIDEO
		INPUT SEL button.
625/50 sig!	on, limit	A 625 system SDI signal was input with	Input a 525 system SDI signal.
		this unit in 525(U) or 525(J) line mode
		(NTSC system) and with “SDI” selected
		with the VIDEO INPUT SEL button.
A mode err!	on, limit	An editing operation was attempted on a	To edit this disc, change the following
		recorded disc, when one of the following	settings.
		audio settings differed from the settings	•	Maintenance menu item “AUDIO
		of this unit.		CONFIG” – “DATA LENGTH”
		• Number of quantizing bits and	•	Maintenance menu item “AUDIO
		recording channels		CONFIG” – “NON-AUDIO INPUT”
		• Handling of digital audio signals (audio
		or non-audio)	See 8-4-2 “Maintenance Menu Operations”
			(page 126) about how to make these
			settings.
NON-AUDIO!	on, limit	An edit preset was attempted on one	Insert editing with non-audio signals must
		channel in an audio channel pair (CH1/2,	be done on a channel pair. To do insert
		CH3/4, CH5/6, CH7/8) when digital	editing with audio signals on a single
		audio signals were set to non-audio.	channel, set maintenance menu item
			“AUDIO CONFIG” - “NON-AUDIO INPUT”
			to “audio.”
			See 8-4-2 “Maintenance Menu Operations”
			(page 126) about how to make this setting.
ILL. REF!	on, limit, off	The playback system and recording	Input a reference video signal to the player
		system are not synchronized.	and recorder.
ILL. REC!	on, limit	A sync error between encoder and input	Contact your Sony service representative.
		signal occurred during recording.
ILL. PLAY!	on, limit	An audio/video phase error occurred
		during playback.
MEM. Full!	on, limit	A memory write error occurred.
MEM. Empty	on, limit	Playback data in memory was lost, and
		playback stopped.

142 9-3 Alarms