Parts of Functions and Names 2 Chapter
mode directly by turning the dial (set extended menu item 101 “SELECTION FOR SEARCH DIAL ENABLE” to “dial”).
fShuttle dial
Turn this for playback in shuttle mode or variable speed mode. Turn clockwise for forward direction playback, and counterclockwise for reverse direction playback.
•In shuttle mode, the playback speed varies in the range ±35 times normal speed (using MPEG IMX/DVCAM), according to the angular position of the shuttle dial.
•In variable speed mode, you can finely adjust the playback speed from
item 301 “VAR SPEED RANGE FOR SYNCHRONIZATION.”
The shuttle dial has a detent at the center position, for still image playback.
Normally, you press the SHUTTLE button before turning the shuttle dial, but it is also possible to make a setting to enable shuttle mode directly by turning the dial (set extended menu item 101 “SELECTION FOR SEARCH DIAL ENABLE” to “dial”).
Note
When extended menu item 101 “SELECTION FOR SEARCH DIAL ENABLE” is set to “dial,” after using the shuttle dial, return it to the center position. If the shuttle dial is not in the center position, it is possible occasionally for vibration from other operations to activate the dial, and start playback in shuttle mode.
7Arrow buttonsThe four arrow buttons are also used as the MARK1 button, MARK2 button, IN button, and OUT button. The correspondence with the buttons is as follows.
Fbutton: MARK1 button f button: MARK2 button G button: IN button
g button: OUT button
You can use these buttons for thumbnail selection, menu setting operations, setting IN/OUT points, and so on.
1F/MARK1 button and f/MARK2 button
2 G/IN button and g/OUT button
ESSENCE S.SEL
MARKMARK1
INOUT
MARK2
3IN indicator and OUT indicator
aF/MARK1 button and f/MARK2 button
When the THUMBNAIL button (see page 21) is lit, you can use these for thumbnail selection.
During recording and playback, the F/MARK1 and f/ MARK2 buttons can be pressed with the SET button held down to record a shot mark 1 or shot mark 2 as an essence mark.
To delete or change essence marks, use the supplied PDZ- 1 Proxy Browsing Software.
bG/IN button and g/OUT button
When the THUMBNAIL button (see page 21) is lit, you can use these for thumbnail selection.
An In or Out point is set when you press the SET button with the G/IN or g/OUT button held down. The In or Out point setting is deleted when you press the RESET button with the G/IN or g/OUT button held down.
cIN indicator and OUT indicator
IN indicator: When an IN point is set, this lights. If an attempt is made to set the IN point after a recorded OUT point, this flashes.
OUT indicator: When an OUT point is set, this lights. If an attempt is made to set the OUT point before a recorded IN point, this flashes.
26