Preparations 3 Chapter
1: i.LINK cable (not supplied)
Laptop computer
| 1 |
To i.LINK (IEEE1394) | S400 (i.LINK) |
| |
connector |
|
Make sure extended menu item 215 “i.LINK
MODE” is set to “FAM (PC REMOTE).”
3-1-3 Connecting to a Nonlinear Editing System
You can send video/audio signals (AV/C data) from this unit to a nonlinear editing system connected to the 
S400 (i.LINK) connector.
The following figure shows an example connection.
Notes
•The 
S400 (i.LINK) connector of this unit outputs video/audio signals in DVCAM format. Data recorded in MPEG IMX format is output after being converted into DVCAM format.
•The nonlinear editing system to be used being connected to this unit requires editing software (not supplied) supporting DVCAM format.
•Make the following settings before transferring video/ audio signals (AV/C data) from this unit to a nonlinear editing system.
Audio mode selection
Use extended menu item 831 “DV OUT AUDIO MODE” to select either of the following.
4ch: 12 bit/32 kHz/4 ch
2ch: 16 bit/48 kHz/2 ch (Factory default setting)
Audio output channel selection
Select the audio output channels with extended menu item 828 “SDI/DV AUDIO OUTPUT SELECT.”
For information about how to make extended menu item settings, see
1: i.LINK cable (not supplied)
To i.LINK(IEEE1394) connector 1
S400 (i.LINK)
Laptop computer
(With editing software supporting
DVCAM format installed)
Make sure extended menu item 215 “i.LINK MODE” is set to “AV/C.”
For the method of transferring video/audio signals (AV/C data) to a nonlinear editing system, refer to the manual provided with the editing software to be used.
34