-The user-defined name or standard format name is displayed for clips without a title.

•If the firmware of your XDCAM device is version 1.4x or lower, clips with user-defined names appear as “C5000” to “C9999,” in order of recording.

7-2File Access Mode File Operations

File access mode operating environment

Operating system requirements for file operations by file access mode (called FAM below) are as follows.

•Computer operating system: Microsoft Windows 2000 Service Pack 4 or higher, or Microsoft Windows XP

Preparations

Do the following on the remote computer and this unit.

•Install the FAM driver on the remote computer (see the next section).

•Set extended menu item 215 “i.LINK MODE” to “FAM.”

See 8-3-2 “Extended Menu Operations” (page 120) for more information about how to make this setting.

To install the FAM driver

Insert the supplied CD-ROM (PDZ-1 Proxy Browsing Software) in the CD-ROM drive of the computer and execute the Setup.exe file, then follow the installation instructions.

For details, refer to the ReadMe file contained on the CD- ROM disc.

Note

Use Version 1.4 or higher of the FAM driver. The FAM driver on the supplied CD-ROM is Version 1.4 or higher. If a FAM driver is already installed on your computer, check the version.

To check the version, click “Add or Remove Programs” (Windows XP) or “Add/Remove Programs” (Windows 2000), select “ProDisc,” and then click “Click here for support information.”

7-2-1 Making FAM Connections

1 If there is a disc loaded in this unit, put the unit into the following state.

•Recording, playback, search and other disc operations (see page 23): Stopped

•THUMBNAIL button (see page 21): Off

•EDIT indicator in status display section (see page 24): Off

•Disc access by DELETE, FORMAT, and so on in the System menu (see page 129): Stopped

•Unsaved current clip list: Save or clear

•Extended menu item 258 “LIVE LOGGING”: off

Operations File 7 Chapter

7-2 File Access Mode File Operations

89