To disable FAM connections

Execute one of the procedures described in the previous section “Reconnecting” to make a FAM connection between this unit and the remote computer. To disable FAM connections, set extended menu item 215 “i.LINK MODE” to “AV/C.”

For more information about how to make this setting, see 8-3-2 “Extended Menu Operations” (page 120).

7-3FTP File Operations

File operations between this unit and a remote computer can be carried out by the File Transfer Protocol (called FTP below).

Preparations

1 Connect the network connectors of this unit and a remote computer with a network cable (see connections illustration on page 32). Or connect this unit to the network to which the remote computer is connected (see connections illustration on page 33).

2 Set the IP address and other network setting items for this unit.

For details, see “To change network settings” (page 127).

If network settings have already been made Check the IP address of this unit.

For details, see “To check the assigned IP address” (page 127).

3 Set the remote control switch to “NETWORK” (see page 20).

7-3-1 Making FTP Connections

FTP connections between this unit and a remote computer can be made with either of the following.

•The command prompt

•FTP client software

This section explains how to use the command prompt. For more information about using FTP client software, refer to the documentation of the FTP client software on your system.

Note

An FTP client that supports UTF-8 is required to use Unicode characters other than ASCII characters. Command prompt FTP commands do not support UTF-8.

To log in

If this unit is connected to a remote computer with a FAM connection, first exit file operations on the FAM connection (see page 90).

1 Load a disc into this unit and put the unit into the following state.

Operations File 7 Chapter

7-3 FTP File Operations

91