Star Micronics LC24-20 Set vertical tab stops every n lines, Select vertical tab channel

Set vertical tab stops

node ] ASCII		I Decimal	I Hexadecimal I
<ESC> “B” Ill	fl~	27 66 nl 112	IB 42 nl n2
Both	<t)>	0	00

Cancels all current vertical tab stops and sets new vertical tab stops at lines nl, n2, etc., where nl, n2, etc. are numbers between 1 and

255.A maximum of 16 vertical tab stops can be set. The tab stops must be specified in ascending order; any violation of ascending order terminates the tab stop list. Standard termination is by the <0> control code. The vertical tab stops are set in terms of the current line spacing and do not move if the line spacing is changed later.

Set vertical tab stops every n lines

Mode	Ascll	Decimal	Hexadecimal
Std.	<ESC> “e” <I> n	27 101 1 n	IB 65 01 n

Cancels all current vertical tab stops and sets new tab stops every n lines. where n is between 2 and 127.

Set vertical tab stops in channel

Mode ASCII		Decimal		Hexadecimal
<ESC> “b” II()	nl	27 98 no	n/	IB 62 no n]
Std.	,... <()>	d	0	n2 00
d

Cancels all current vertical tab stops in channel M, (where nO is between Oand 7) and sets new vertical tab stops in this channel. (A channel is a set of vertical tab stops selected by the <ESC> “/” command.) See <ESC> “B” for parameters nZ, n2, ... <0>.

Select vertical tab channel

Mode	ASCII	Decimal	Hexadecimal
Std.	<ESC> “/” no	27 47 no	IB 2F no

Selects a set of vertical tab stops designated by a channel number (nO)from Oto 7. The tab stops in each channel are set by <ESC> “b”.

102