Star Micronics NR-10, NR-15 user manual Self Declaration

Federal Communications Commission

Radio Frequency Interference Statement

This equipment generates and uses radio frequency energy and if not installed and used

properly, that is. in strict accordance with the manufacturer’s instructions. may cause

interference to radio and television reception. It has been type tested and found to comply

with the limits for a Class B computing device in accordance with the specifications in Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection

against such interference in a residential installation. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause

interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient the receiving antenna

•Relocate the computer with respect to the receiver

•Move the computer away from the receiver

•Plug the computer into a different outlet so that computer and receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced redio/television tech- _

nician for additional suggestions. The user may find the following booklet, prepared

by the Federal Communications Commission helpful: “How to Identify and Resolve

Radio-TV Interference Problems.” This booklet is available from the U.S. Govermnent

Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.

For compliance with Federal Noise Interference Standard. this equipment requires a shielded cable.

This statement will be applied only for the printers. marketed in U.S.A.

Self Declaration

Radio interferences regarding this equipment has been eliminated according to Vfg

1046/1984 announced by the DBP.

DBP has been informed about the introduction of this special equipment and has been conceded the right to examine the whole series.

It is upon the responsibility of the user to assume that his own assembled system is in

accordance with the technical regulations under Vfg 1046/1984.

To observe FTZ-regulations it is necessary, to establish all connections to the printer with shielded cable.

The equipment may only be opened by qualified service representatives.

This statement will be applied onlyfor the printers marketed in West Germany.

Trademark Acknowledgement

p-10/15:Star Micronics Co., Ltd.

Apple II: Apple Computer Inc.

EasyWriter II: Information Unlimited Software, Inc.

m-85: Seiko Epson Corp.

IBM PC, IBM Graphics Printer, IBM Proprinter: International Business Machines Corp.

Lotus l-2-3:Lotus Development Corp.

Microsoft BASIC: Microsoft Corporation

WordStar: MicroPro International Corporation

NOTICE

•All rights reserved. Reproduction of any part of this manual in any form what- soever, without STAR’s express permission is forbidden.

•The contents of this manual are subject to change without notice.

•All efforts have been made to ensure the accuracy of the contents of this manual at the time of going to press. However, should any errors be detected, STAR would be greatly appreciate being informed of them.

•The above notwithstanding, STAR can assume no responsibility for any errors in this manual.

@Copyright 1986 Star Micronics Co., Ltd.