Program Setting Times and Display Information
The LCD window will tell you if there is a problem with your SmartBake CUSTOM. Always use your SmartBake CUSTOM in a room free of drafts. Do not use your
SmartBake CUSTOM outdoors, near a heat vent or in direct sunlight.
DISPLAY READS | PROBLEM | SOLUTION | |
|
|
| |
“0:00” (:) flashing | Select program setting | Use the Menu button to | |
|
| select program. | |
|
|
| |
“E:01” flashing | The baking chamber is too | Open the lid and remove | |
| hot to begin another cycle | bread pan to cool the chamber. | |
|
| After the panel message disappears, | |
|
| put the bread pan back into the | |
|
| chamber and press START again. | |
|
|
| |
“E:02” flashing | Sensor malfunction | Allow the baking chamber | |
|
| ||
“E:03” flashing | Sensor malfunction | to cool, then restart your | |
programming. If the error | |||
|
| ||
“E:04” flashing | CPU malfunction | continues contact Customer | |
“E:05” flashing | Heater control malfunction | Service on | |
Australia 1300 881 861. | |||
“E:08” flashing | Heater control malfunction | New Zealand 0800 786 232 | |
| |||
|
|
|
Note: After baking a loaf of bread, it is recommended to cool the breadmaker down to room temperature as temperatures above ambient reduce the rising height of the bread due to the sensitivity of yeast.
You will hear a beep when:
The power is turned ON | Long beep |
Select a setting from the Menu | Short beep |
Completion of bread baking process | Short and Long beeps |
Tip: Display Window Sleep Mode. The Screen will change to sleep mode after 20 minutes and the screen will darken. Push any button to light up the screen again.
66
