SRC-7000 User’s Manual
1. | 2. | 3. |
1.Decide the “Device Category” for your device by pressing the 
or 
buttons. Press the 
to confirm and enter to next step.
2.Decide how you will load the IR remote codes for the device.
Select 
to confirm.
3.
Choose the first letter of targeted device brand (ex. “S” on behalf of Sony, Samsung…etc), and point the
Tap 
soft button to start auto searching. When you see the targeted device has been turned off, tap or press any button
immediately to stop auto searching. Then press 
to test the power key. If it can’t work, please go through 
step as below.
Tap 
or 
gently to figure out the correct remote code (Code number as shown on the top middle position of the LCD.) until the targeted device has been turned on again. Press the power key or the hard key to test and to confirm the codes.
If the codes are not correct please repeat 
steps and select “All”. Repeat the 
~
again to find the proper code for your target device.
4.If they work, it means that you have found the correct remote
codes. Please press the 
button to confirm your decision.
When you are in step 3 you will see an icon 
located on the
24
