Sunwave Tech SRC-7000 manual Trying to configure

Problem		Solution
You see an “error” display	•	The key that you pressed has not been taught or input the IR
during operation.		code.
	•	Teach the key via learning procedure. (P.37)
IR Learning is not	•	Do not use the learn function near an incandescent lamp.
successful.	•	Memory capacity is full (64 keys for each device.).
	•	Replace new batteries in the SRC-7000 and the remote you are
		trying to configure.
	•	Keep the learning distance between the remote control and
		SRC-7000’s learning eye about 2~4 inches apart (5-10cm).
	•	The learning process has no errors, but you still can’t control
		your target devices:
		- The battery in the target remote doesn’t have enough
		power.
		- Original remote might not be compatible with learning
		procedure. Repeat the learning procedure again.
		- If you still can’t solve the problem, contact SUNWAVE for
		help.
Macro does not work.	•	Be sure to aim the SRC-7000 at the devices while the Macro
		commands are being sent.
	•	Macro was not properly set up. Repeat macro set-up
		procedure. (P.42)
A key of your existing	•	Some remotes issue multiple commands when a key is held
remote performs two or
		down. Please be sure to teach different keys of SRC-7000 for
more functions
		these different commands.
	•	Each key of SRC-7000 can learn 6 commands in a Cycle key.
		(P.40)
The LCD screen turns off.	•	The SRC-7000 is preset automatically to switch the LCD off
		after 1 minute by default if left unused. You can also setup the
		idle time to turns off the LCD. (P.54)
	•	You can turn on the SRC-7000 again as followed:
		- Tap the touch screen
		- Pick up the SRC-7000
		- Press the hard key
The touch panel isn’t	•	Please re-calibrate your touch panel (P.17)
sensitivity

73