Sunwave Tech SRC-7000 manual Appendix C, Troubleshooting Tables

Appendix C

Troubleshooting Tables

Problem		Solution
LCD does not show	•	Batteries may be dead.
anything when you touch it.
	•	Replace the batteries with three new AAA Alkaline batteries.
	•	Check the batteries are properly insert with the + - indications.
	•	Reset the SRC-7000 by press the reset switch. (P.9 o.)
The SRC-7000 doesn’t	•	Make sure that the desired device on the SRC-7000 LCD panel
operate a device.		has been selected.
	•	Move SRC-7000 closer to the device. The maximum operating
		distance is approximately 10 meters (30 feet).
	•	Ensure that you are aiming the SRC-7000 directly at the device
		and there are no obstructions between the SRC-7000 and the
		device.
	•	Ensure that you have correctly used the learning function to
		configure the device or the Pre-Programmed Code has been
		properly applied.
	•	Re-teach the malfunctioning key.
	•	The device has already plugged the power.
You cannot operate a	•	Make sure that your SRC-7000 has correctly learned the target
device even after teaching		device’s remote control code.
the device by using the	•	Delete the device data from the SRC-7000 and carry out the
learning function.		learning function again.
	•	Make sure you did not program more than one remote for a
		given device.
You see an “error” display	•	Make sure you hold the target remote’s key till the screen
on the LCD screen during		displays OK or Error on the screen.
the learning procedure.	•	Make sure the two remotes are not too close or too far apart –
		keep them about 2~4 inches (5~10 cm) apart, and your device
		remote control is aimed directly at the SRC-7000’s learning
		eye.
	•	The batteries are sufficient with both SRC-7000 & the target
		remote control.

72