Item

Explanation

 

 

 

Values: 0 ~ 300 sec *15 sec

 

You can set the time length the printer waits

Job Time Out

before printing the last page of a print job

 

that does not end with a command to print

 

the page.

 

When a print time-out occurs, the printer

 

prints the page in the print buffer.

 

 

 

This item is only available if the optional

 

serial interface card is installed in your

 

printer. For details, see page E.6.

 

Baud Rate: Lets you select the rate at

 

which data is being sent to or from your

 

computer using the serial communication.

RS-232C

Note that using a setting higher than

19200 bps with the COM port may cause

 

unexpected errors in DOS mode.

 

Robust XON: Turns use of XON/OFF of

 

serial communication control on or off.

 

When this item is set to On, the printer

 

sends a continuous stream of XONs to the

 

computer to indicate that the serial port is

 

ready to receive more data.

 

 

 

This item allows you to maintain the toner

 

cartridge.

 

OPC Cleaning: Cleans the OPC drum of

 

the cartridge and produces a cleaning

Maintenance

sheet with toner debris on it.

Fuser Cleaning: Cleans the fuser unit

 

inside of the printer and produces a

 

cleaning sheet with toner debris on it.

 

Remain Toner: This item allows you to

 

check how much toner are left in the

 

cartridge.

 

 

3

USING THE CONTROL PANEL 3.15

Page 56
Image 56
Tally Genicom 9025N Job Time Out Before printing the last page of a print job, When a print time-out occurs, the printer