Tally Genicom 9025N manual Open the Multi-Purpose Tray and the rear output tray

1Open the Multi-Purpose Tray and the rear output tray.

2Load print material with print side up and short edge first. Adjust the guide to fit the width of the material stack.

3 When you print, configure the paper source, type and size 4

properly in the software application. For details, see page 5.7.

NOTE: If the size of your print material is not listed in the Size box in the Paper tab of the printer driver properties, click the Custom button and set the size manually. See page 5.7.

CAUTIONS: When you use 76 by 127 mm (3 by 5 in. )paper and it is too thin, a paper jam may occur. Use the card stock heavier than

105g/m2

For details about setting on the control panel, see page page 3.5.

4After printing, close the Multi-Purpose Tray and the rear output tray.

USING PRINT MATERIALS 4.23