Tally Genicom 9025N manual Dynamic Addressing BOOTP/DHCP

11Press the Enter button () to access the IP Address menu.

IP address consists of 4 bytes.

Enter a number between 0 and 255 for each byte.

12Press the scroll button ( or ) to enter a number between 0 and 255 and press the Enter button ().

13Repeat Step 12 to complete the address from the 1st byte to the 4th byte.

14To select other parameters, such as Subnet Mask or Gateway, press the Upper Level button ( ), then use the scroll button ( or ). Press the Enter button ().

15Repeat steps 12 and 13 to configure the other TCP/IP parameters.

16Press the ON Line/Continue button ( ) to return to ready mode.

Dynamic Addressing (BOOTP/DHCP)

To assign the TCP/IP address automatically by the server, take the following steps:

1In ready mode press the Menu button ( ) until you see “Network” on the bottom line of the display. Press the Enter button () to access the menu.

2Press the Enter button () when “Config Network” displays on the bottom line.

3 Press the scroll button (	or	) to display “Yes” and
press the Enter button (	).	D

4press the Upper Level button ( ), then use the scroll button ( ).

5Press the Enter button () when “Config TCP” displays.

USING YOUR PRINTER ON A NETWORK D.9