Table 1 describes the SNMP default configuration:
Feature: | Default Setting: |
|
SNMP Community Strings: | Read: | Read |
| Read/Write: | ReadWrite |
| System Location: | Nothing |
| System Contact: | Nothing |
SNMP Trap IPs: | None configured |
|
SNMP Traps: | None enabled |
|
Table 1: SNMP Default Configuration
In addition, the SNMP standards allow you to enter the location of the system (i.e. “Row 11, Rack C”) and specify an administrative contact for the system (i.e. “Pat Smith, (713)
The following sections demonstrate how to change the default SNMP strings. Changing these values causes the RamSan to use the new string when sending SNMP messages.
Via Text Management
•From the Telnet Main Menu, select “Management setup”
•Select “Configure SNMP”
Figure 8-1: SNMP Configuration via Text Management Interface
The top of this menu displays the current SNMP settings.
To change the read community name:
•Select “Change read community name”
•Enter the read community name and press [ENTER]
To change the read/write community name:
•Select “Change read/write community name”
•Enter the read/write community name and press [ENTER]
| - 93 - |
