Timex Performance Watch manual To SET Time of DAY, To Switch Time Zones

You can return to Time of Day Mode from any other mode on the

Watch by pressing and holding MODE until the time of day displays.

TO SET TIME OF DAY

For instructions on setting Watch functions, including Time of Day, refer to page 13, ÒTo set Watch functions.Ó

For Time of Day, you can set the following values:

ϖ	Hour	ϖ	Month
ϖ	Minute	ϖ	Date (automatically sets the day of week
			when you set the date)
ϖ	Year	ϖ	Hour format (i.e., AM/PM versus 24-hours)

NOTE: You cannot adjust seconds. When you use the Watch with the GPS-3D Sensor, it will align with UTC.

When switching between Standard Time and Daylight Savings Time, manually adjust the hour.

You can set the Watch slightly ahead or behind current time. For example, if you typically arrive ten minutes late, set the Watch ten minutes ahead. The Watch remains ahead of time even when you synchronize it with the GPS-3D Sensor.

TO SWITCH TIME ZONES

The Watch can track two time zones (T1 and T2). Look at the other zone by pressing START/SPLIT. Or, switch from T1 to T2 using these steps:

1.Press and hold START/SPLIT until HOLD FOR TIME 2 displays.

2.Continue to hold until the time switches and the Watch beeps.

3.Repeat steps 1 and 2 to switch back to T1. The message will read HOLD FOR TIME 1.

You must independently set the time of day for each time zone.

TO SYNCHRONIZE TIME OF DAY WITH FITNESS SENSORS

When you first activate the GPS-3D Sensor in conjunction with your Watch, you can expect one of the following scenarios:

ϖIf you activate the GPS-3D Sensor before setting the time of day, the Watch will synchronize both T1 and T2 with UTC. You will need to adjust the hour for both time zones to your local time.

ϖIf you activate the GPS-3D Sensor after setting the time of day, the Watch maintains the hour and date settings and synchronizes minutes and seconds to UTC for each time zone.

20 21