Timex Performance Watch manual Altitude Settings, HANDS-FREE Settings

ϖSpeed Smoothing: Turn speed smoothing off or on.

ϖPace Smoothing: Turn pace smoothing off or on.

ALTITUDE SETTINGS

Smoothing: Smoothing is useful if you feel that the displayed altitude values appear to be too erratic. Smoothing applies an averaging filter and may cause the displayed altitude values to respond more slowly to changes.

Configure the following altitude settings:

ϖTarget Altitude: Set the target altitude to alert you when you move above a specified altitude. When you reach the target altitude, the Watch beeps and begins timing. If you move below the target altitude, the Watch suspends timing until you once again move above the target altitude.

ϖMax Altitude: Set the max altitude to alert you if you move above an altitude value you do not wish to exceed. If you exceed your altitude, the Watch will beep until you move below the maximum altitude.

ϖSmoothing: Turn altitude smoothing off or on.

ϖUpdate Ascent Rate: Set the Watch to update the period at which the ascent rate is calculated. You can choose intervals of 30 seconds, or one, 10, 30, or 60 minutes. Set this feature shorter for faster vertical activities such as skiing or longer for slower vertical activities such as climbing.

HANDS-FREE SETTINGS

Hands-free features operate in conjunction with the GPS-3D Sensor. They automate chronograph features, freeing you to focus on your workout instead of operating your Watch.

Configure the following hands-free settings:

ϖAuto Split: This feature enables the chronograph to automatically take splits based on intervals (when you set intervals in Timer Mode), or by a distance, altitude, or a time you determine. For instance, you can configure the Watch to take a split every mile and then you can compare data for each mile in Lap Data Mode after you complete your activity.

ϖAuto Start: This feature enables the chronograph to start when you start moving. It may take a few seconds for the GPS- 3D Sensor to detect your movement, causing a slight delay in start time.

ϖAuto Stop: This feature enables the chronograph to stop when you stop moving. It may take a few seconds for the GPS-3D Sensor to detect that you have stopped moving, causing a slight delay in stop time.

NOTE: Even when enabled, you can still start and stop the chronograph manually and take manual splits without affecting the hands-free operation.

62 63