
6.4.9. Channel designation
Sets the first channel (camera number) to be displayed after the power is turned ON.
Note
This channel setting can only be performed when one of the settings "1. FULL," "4.
Step 1. Press the Menu key to display the menu screen.
Step 2. Tilt the joystick up or down to select "INITIAL CHANNEL," then confirm the selection with the SET key. The setting corresponding to the Initial Screen setting is displayed on Line 2.
Step 3. Using the joystick and numeric keypad, select the setting depending on the "Initial screen" setting, and confirm the selected setting with the SET key. (Refer to the table shown below.)
[Setting contents]
"Initial screen" Setting | Setting |
1. FULL | Enter the channel to be designated with the numeric keypad, and confirm |
(full screen) | the setting with the SET key. |
|
|
| I N I T I A L C H A N N E L | |||||
|
|
| C H A N N E L | 1 | 2 3 | |||
| Note: This selection is set to "1" by the factory. | |||||||
|
|
|
|
|
|
|
|
|
4. | Tilt the joystick to the left or right to select "1 – 4," "5 – 8," "9 – 12," or "13 – | |||||||
16" and confirm with the SET key. | ||||||||
display) |
|
|
|
|
|
|
|
|
|
|
| I N I T I A L C H A N N E L | |||||
|
| 1 |
| 4 |
|
| ||
|
|
| ||||||
| Note: This selection is set to "1 – 4" by the factory. | |||||||
|
|
|
|
|
|
|
|
|
5. | Tilt the joystick to the left or right to select "1 – 9" or "10 – 16," and confirm | |||||||
with the SET key. |
|
|
|
|
| |||
display) |
|
| I N I T I A L C H A N N E L | |||||
|
|
| ||||||
|
| 1 |
| 9 |
|
| ||
|
|
|
|
Note: This selection is set to "1 – 9" by the factory.
6. | Tilt the joystick to the left or right to select "1 – 8" or "9 – 16," and confirm | |||
with the SET key. |
|
| ||
display) |
|
|
|
|
|
| I N I T I A L C H A N N E L | ||
|
|
|
| 8 |
| 1 | |||
|
|
|
Notes
•Make sure that this setting is the same as that of the connected switcher.
•This selection is set to "1 – 8" by the factory.
31