8 Transporting
warning
When transporting the UPS by crane, follow the SPECIFIED WORK PROCEDURE. The suspension wire angle should be less than 60°.
The UPS falling or overturning may cause crushing, trapping or other personal injuries.
DO NOT tilt the UPS more than 10° from upright position.
Tilting the UPS more than 10° may cause crushing, trapping or other personal injuries.
caution
DO NOT transport, move, store, or place the UPS on its side.
Excessive force applied from heavy components inside may damage the UPS.
Do NOT expose the unit to vibration or shock exceeding 0.5G.
Excessive vibration or shock may cause damage to the UPS.
DO NOT allow the UPS to suffer shock or impact when unpacking.
Tools used to remove packaging materials may cause damage to the
UPS.
DO NOT install the UPS where water may fall on it.
Water may cause electrical shock, personal injury or UPS failure.
DO NOT push or pull on the sides of the packaging.or the UPS to move it. Always use a crane, forklift, or pallet jack for transporting and positioning the UPS.
Pushing/pulling on the sides of the unit to move it may result in damage to the UPS. (See Figure 4.1 Exterior Handling label.)
The UPS may be packed in a crate for extra protection during transportation. Avoid impact or vibration against the UPS during transportation. DO NOT expose the UPS directly to water.
G8000 Series with Isolated Output Installation and Operation Manual | 19 |
