Power and
Connecting and disconnecting the Slice Expansion Battery
This battery pack increases your computer's operating time when a main battery pack is also installed.
This section explains how to connect and disconnect the Slice Expansion Battery, and begins with the removal process which is detailed through the following steps.
Connecting the Slice Expansion Battery
To connect the Slice Expansion Battery to the computer, follow the steps as detailed below:
When handling Slice Expansion Battery, be careful not to short circuit the terminals. Also do not drop, hit or otherwise apply impact; do not scratch or break the casing and do not twist or bend the latches of it.
1.Be sure the computer’s power is off and all cables are disconnected.
2.Close the display panel and turn the computer upside down.
3.Remove the protective cap from the Slice Expansion Battery.
4.Open latches on the Slice Expansion Battery and fit a tab on the battery into the hole on the underside of the computer.
5.Connect the Slice Expansion Battery's connector to the docking port.
Latches
Tab
Hole
Docking port
Figure 6-3 Seating the Slice Expansion Battery
User’s Manual |
