Toshiba TECRA R10 user manual Cpu

HW Setup

CPU

This function allows you to set the processor's operating mode.

Dynamic CPU Frequency Mode

This option allows you to configure the power saving modes associated with the processor - the following settings are available:

Dynamically	The processor's power consumption and
Switchable	automatic clock speed switching functions are
	enabled - in use the processor's operation is
	automatically switched when necessary (default).
Always High	The processor's power consumption and
	automatic clock speed switching functions are
	disabled - in use the processor will always run at
	its highest level of power consumption and its
	highest speed.
Always Low	The processor's power consumption and
	automatic clock speed switching functions are
	disabled - in use the processor will always run at
	a lower level of power consumption and a low
	speed.

LAN

Wake-up on LAN

This feature lets the computer’s power be turned on when it receives a wake-up signal from the LAN.

Do not install or remove a memory module while Wake-up on LAN is enabled.

■The Wake-up on LAN function consumes power even when the system is off. Leave the AC adaptor connected while using this feature.

■To enable it, you must check both the "Allow the device to wake the computer" and "Only allow management stations to wake the computer" check box within the "Intel Network Connection".

Power will be automatically turned on when a signal is received from an administrator's computer which is connected via a network.

The following settings can be changed when the Built-in LAN is Enabled. Connect the AC adaptor when using the Wake-up on LAN function. The battery retention time will be shorter than the times listed in this manual when this function is enabled. Refer to the section in chapter 6, Retaining data with power off.

Enabled	Enables Wake-up on LAN (Default).
Disabled	Disables Wake-up on LAN.

User’s Manual 7-6