Toshiba TECRA R10 user manual Lan

Troubleshooting

Problem	Procedure
	When the display panel and an external monitor
	are set to clone mode and they are turned off by
	the timer, the display panel or the external
	monitor may not display when turned on again.
	If this occurs, press FN + F5 to re-set the display
	panel and external monitor to clone mode.
Display error occurs	Check that the cable connecting the external
	monitor to the computer is firmly attached.
	If you are still unable to resolve the problem,
	contact your reseller, dealer or service provider.

LAN

	Problem	Procedure
	Cannot access LAN	Check for a firm cable connection between the
		LAN jack and the LAN hub.
	Wake-up on LAN does	Make sure the AC adaptor is connected. The
	not work	Wake-up on LAN function consumes power even
		when the system is off.
		If problems persist, consult your LAN
		administrator.
Wireless LAN

If the following procedures do not restore LAN access, consult your LAN administrator. For more information on wireless communication, refer to Chapter 4, Operating Basics.

Problem	Procedure
Cannot access	Make sure the computer's Wireless
Wireless LAN	communication switch is set to on.
Wake-up on Wireless	Make sure the AC adaptor is connected. The
LAN does not work	Wake-up on Wireless LAN function consumes
	power even when the system is off.
	If problems persist, contact your LAN
	administrator.

User’s Manual 8-20