Replacement Procedures
Figure 4-14-3 Disconnect the touch pad flat cable/Fingerprint cable
Installing Top Cover assembly
The following describes the procedure for installing the top cover assembly. 1. Install the top cover assembly to the base assembly.
NOTE: Be careful not to catch the cables between top cover assembly and base assembly.
2.Connect the touch pad flat cable to the connector on the system board.
3.Secure the top cover assembly with following screws from the front of computer.
| M2.5x6.5 | Flat BIND screws | x7 |
| M2.5x3.0 | Flat BIND screws | x2 |
4.Secure the top cover assembly with the following screws from the back and bottom of computer.
| M2.5×2.0 | FLAT BIND screw | x5 | | M2.5×6.5 | FLAT BIND screw | x11 | ||
| M2.5×8.0 | FLAT BIND screw | x6 | | M2.5×4.0 | FLAT BIND screw | x2 | ||
| M2.5×3.0 | FLAT BIND screw | x1 |
|
|
|
|
|
|
| 5. Free the cable from |
|
|
| |||||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
Qosmio X500 Maintenance Manual |
|
|
|
| |||||
