VBrick Systems VB5000, VB6000, VB4000 manual Diagnostics Device Test, Trace Route Test Results

Diagnostics

Probe Count

Can be set from 3 to 20. The default setting is 3. This setting is the number of probe packets sent to a host at each hop.

Trace Route Test Results

The results of the test appear at the top of the screen. The results include the Resolved IP Address of the Destination Host Name. When the test is finished or stopped, the Overall Result will display the result of the test, such as "Test Done," or "Max hops (=30) Finished," or "Test Stopped," etc. An entry shows the hop number, which is equal to the TTL, IP address (and Host Name if available) of the gateway, and round trip time of each probe. If the probe answers are received from different gateways, the address of each responding system will be shown. If there is no response within a 5 second timeout interval, a "*" is printed for that probe. If the result string exceeds 255 characters, the string will be terminated by ending it with "Too Long."

Diagnostics: Device Test

The WM Appliance automatically performs a full POST (Power On Self Test) hardware test at power-on or reset. The results are shown on this page.

TTo run the Device Test:

1.Go to Configuration: System > General.

2.Set the Configured Operational Mode to Diagnostics. (After you press Apply, the

appliance will reboot. Wait until the front panel displays "Diagnostic Mode.")

3.Go to Diagnostic: Device Test and click Begin Edit.

4.Set test parameters (see below).

5.Click Start, then wait a few seconds and click Refresh to see the test results.

VBrick WM Appliance Admin Guide 115