Diagnostics

Diagnostics: Hard Drive

Hard Drive Format

Use carefully. Removes all content and reformats the hard drive.

 

 

Check Disk

Runs the Check Disk utility. You must be in Diagnostic Mode to

 

start Check Disk. See below.

 

 

TTo run Check Disk:

1.Go to Configuration: System > General.

2.Set the Configured Operational Mode to Diagnostics. (After you press Apply, the

appliance will reboot. Wait until the front panel displays "Diagnostic Mode.")

3.Go to Diagnostic: Hard Drive and click Begin Edit.

4.Click Start to run the utility. (Note that the Start button is only shown in Diagnostic

Mode.

5.Click Refresh to see the results.

6.When done, reset Configured Operational Mode to Run.

VBrick WM Appliance Admin Guide

117

Page 127
Image 127
VBrick Systems VB4000, VB6000, VB5000 manual Diagnostics Hard Drive