
WM Configuration
Audio Input | • | Audio Jack – Input from standard audio source. like a DVD player. |
| • | Microphone DIN – Input from VBrick's AudioMate microphone. |
Note: When you select Microphone DIN as the encoder Audio Input, the left audio jack input is switched off but the right audio jack input remains connected. This means that if there is an audio source connected to the right audio jack input, you can mix this input with the Microphone DIN input by setting the encoder Audio Channels value
to either Stereo or Mono (L+R).
Audio Input Level | Normal or Alternate. Default = Normal. Sets the audio level for the |
| encoder audio jack or microphone input. When set to normal, the |
| audio inputs accept a |
| to alternate, the audio inputs accept an |
| signal. |
|
|
Audio Gain | This setting controls the audio level of the encoder: |
| • When the Audio Input Level is set to Normal, the settings are from |
| 49 to |
| and |
| labeled (mic) when using a standard microphone through the Audio |
| Jack inputs. |
| • When the Audio Input Level is set to Alternate, the settings are |
| from 12 to |
| volume and |
Audio Template Settings
Note In Edit mode, the parameters affected by template settings (set in the Configuration: Encoder > Template) are shown at the bottom of the screen. These settings override the template; they do not change the template.
The following audio settings can be changed by modifying a template setting in the Configuration: Encoder > Template section of IWS. Any changes you make on this window override the template; they do not change it. See Table 11, Audio Channels: Stereo/Mono † for Bit Rate and Sample Frequency matrix.
Audio Channels | Audio Channels – The audio output mode can be configured to one of |
| three possible settings: |
•Stereo – Stereo directs the input left channel to the left channel in the audio stream and the input right channel to the right channel in the audio stream.
•Mono (L+R) – A combination of both the left and right channel is encoded to a single channel. The Media Player will play the audio through both speakers.
•Mono (left only) – Only the left input channel is carried in the stream. The Media Player will play the audio through both speakers.
L+R Bit Rate | See Bit Rate and Sample Frequency for all settings. The value can be |
| |
| bit rate of the audio stream. |
VBrick WM Appliance Admin Guide | 33 |