Network Time Synchronization

These fields are used to synchronize network time using the host name or IP address of a known server to provide a synchronized time for all appliances in the network. To enable Network Time Synchronization after these parameters are set, go to Configuration: System > General on page 76 and check the box.

Note Network Administrators please note. DHCP Option 4 is used by the DHCP server to return SNTP server addresses. This option must be enabled in the DHCP server for these addresses to be returned to the VBrick. If the DHCP server configuration is unknown, it is recommended that the address(es) be manually entered since the DHCP server-supplied address will always override a manually-entered address.

Primary Server IP

Primary host name (VBrick Host Name or DNS Host Name) or IP

Address or Host Name

address of valid SNTP server providing time synchronization. A

 

blank field indicates the server address will be acquired via the

 

DHCP server only if the Network DHCP field above is checked.

 

 

Secondary Server IP

Secondary host name (VBrick Host Name or DNS Host Name) or

Address or Host Name

IP address of valid SNTP server providing time synchronization. A

 

blank field indicates the server address will be acquired via the

 

DHCP server only if the Network DHCP field above is checked.

 

 

Configuration: Network > Routing

The WM Appliance requires no routing configuration for the vast majority of network uses. Use these settings only in those rare cases when your network requires advanced routing features in the appliance.

20

© 2008 VBrick Systems, Inc.

Page 29 Page 31
Page 30
Image 30
VBrick Systems VB6000, VB4000, VB5000 manual Configuration Network Routing, Network Time Synchronization
Page 29 Page 31
Top Page Image Contents