VBrick Systems VB5000, VB6000, VB4000 manual Jpeg Configuration

WM Configuration

JPEG Configuration

The following fields enable image capture and specify the capture interval and compression quality. Note that if you change any of these parameters for a live encoder stream, there will be a momentary (10 seconds or less) loss of video. (For JPEG capture status, see Status:

JPEG Status on page 100.)

Image Capture Enable	Check this box to enable image capture. Default = disabled.
	Note that toggling this parameter on or off will reboot the
	appliance.
Image Capture Interval	1–600 seconds. Specify the interval at which images are
	captured. Default = 5.
JPEG Compression Quality	0–100. Values over 80 marginally affect image quality and
	may impact other system resources. For best results,
	experiment with the output and choose the lowest value that
	provides acceptable image quality. Default = 80.
Deinterlaced Image Enable	Vertical resolutions above 288 lines are deinterlaced to
	provide higher vertical resolutions. Deinterlacing while there
	is motion on the encoded video can cause visual artifacts on
	the captured JPEG image. Be aware that disabling interlacing
	removes the visual artifacts but creates a JPEG image that is one
	half the height and one half the width of the original resolution. For
	example, a 640x480 video resolution will be encoded as a
	320x240 JPEG file. Default = Disabled. Note that toggling
	this parameter on or off will reboot the appliance.

VBrick WM Appliance Admin Guide 67