Vertex Standard FTM-10R manual Separate Installation

INSTALLATION

SEPARATE INSTALLATION

1.	Remove the four screws securing the
	Front Panel and then remove the Front
	Panel from the Transceiver Body
	(Figure 1).
2.	Disconnect the 8-pin modular plug
	from the Transceiver (Figure 2).
3.	Remove the screw affixing the Straight
	Sub Panel, and then remove the
	Straight Sub Panel from the Front Panel	Figure 1
	(Figure 3).
4.	Remove the four screws securing the
	Rear Case of the Front Panel and re-
	move the Rear Case from the Front
	Panel (Figure 4). Disconnect the Con-
	nector of the Connection Cable from
	the Printed Circuit Board in the Front
	Panel when you remove the Rear Case
	(Figure 5).
5.	Remove the Binding Plate from the
	Rear Case (Figure 6-), and then pull
	out the Connection Cable from the Rear
	Case (Figure 6-).

Figure 2

Figure 3

Figure 4

connector

Figure 5



Figure 6

16 FTM-10R OPERATING MANUAL