Vertex Standard FTM-10R manual Dtmf Autodialer, To load the DTMFAutodialer memories

DTMF AUTODIALER

Nine Autodialer memories are available on the FTM-10R. These DTMF Autodialer memories can store up to 16 digits of a telephone number for repeater autopatch or other use.

To load the DTMFAutodialer memories:

1.	Press and hold the [VOL/SEL] key for one second to activate the Menu mode.
2.	Rotate the DIAL knob to select Menu Item “F13 DTMF”.
3.	Press the	key to enable selection of this Menu item.
4.	Rotate the DIAL knob to select the DTMF AutoDial memory
	channel number into which you wish to store a telephone
	number (“D1” to “D9”). The previously stored telephone
	number is displayed on the LCD.
5.	Press and hold the		key for one second.
	Press the PTT key to clear any previously stored telephone
	number, if desired.
6.	Rotate the DIAL knob to select the first digit of the tele-
	phone number you wish to store. Then press the			key

momentarily to save the first digit of the telephone number and move on to the next digit.

“E” representing DTMF “*” and “F” representing DTMF “#”

7.Repeat previous step for each digit in the telephone number. If you make a mistake,

press the key to move the cursor back to the previous digit, then re-enter the correct number.

Press the PTT key to delete all data after the cursor that may have been previously stored erroneously.

8.When entries of all digits are complete, press and hold the key for one second.

9.If you wish to store another DTMF string, repeat steps 4 through 8 above.

10.Press the [VOL/SEL] key momentarily to save the new setting and exit to normal op- eration.

FTM-10R OPERATING MANUAL 71