West Bend Back to Basics UX-CC500 manual Turning the Transfer function on and off, Function

Transfer Function

Turning the Transfer function on and off

When you go out and wish to use the Transfer function, turn it on as follows:

1					Display:
	Press FUNCTION once and			once.	T.A.D. SETTING
2	Press		once and	4 times.	TRANSFER FUNC
3	Press	.			1=YES, 2=NO
4	Press		to turn on the Transfer		The display briefly shows
		1			your selection, then:
	function.				ON TAD FAILURE
	(Press	2	to turn the function off.)

5 Press the number of the box for which you want the Transfer function to

operate (for the general box, press 0 ).

6	Press	STOP	to return to the date and time display.
7
	Each time the machine receives an incoming message, it will call your
	programmed transfer number. When you answer, you will hear your
	recorded message telling you that the call is a transfer call. On the dial

pad of your phone, enter , your remote code number (see page 62) if the general box was selected in Step 5, or the box passcode number if a

personal box was selected, and then . Your messages will play.

•You can also perform any of the remote operations described in Remote Operations later in this chapter (see page 62).

Note: When you hang up after a transfer call, the machine will not immediately resume normal operation. If you want the machine to accept calls

immediately after a transfer call, enter twice before hanging up (if

hanging up during message playback, first enter 0 and to stop

playback, then enter twice).

Answering	Machine
3.

61