Sending a Fax by Automatic Dialing

Redial

You can automatically redial the last number dialed on the fax machine. This procedure can be used to send a fax or make a phone call.

Note: The fax machine and the cordless handset each retain their own separate redial numbers.

1 If you are sending a fax, load the document(s).

RESOLUTION/

If desired, press RECEPTION MODE to set the

 

resolution and/or contrast.

2 Press once. <REDIAL> appears in the display, followed by the last

number dialed. Make sure the number that appears is the number you wish to dial.

3 If you are sending a fax, press START/MEMORY . Dialing begins.

If you are making a phone call, lift the handset. Dialing begins.

Note: If a fax transmission is unsuccessful and DOCUMENT JAMMED appears in the display, remove the document as explained on page 119. (This may occur if the other fax machine doesn’t respond properly when you attempt to send the document.)

Sending

Faxes

4.

 

Automatic redialing

If you use automatic dialing (including Direct Keypad Dialing) to send a fax and the line is busy, the fax machine will automatically redial the number. The fax machine will make three redial attempts at intervals of five minutes. During this time, RECALLING will appear in the display, followed by a two-digit number assigned to the fax job. You will not be able to dial any other locations while the message appears.

79

Page 81
Image 81
West Bend Back to Basics UX-CC500 manual Redial, Automatic redialing