Westell Technologies 7400, 7401 manual Warning Message, Check Public LAN DHCP Settings

User Guide UltraLine Home DSL Router (Models 7400, 7401)

If the settings you have entered in the Public LAN Configuration screen are incorrect, the following warnings messages may be displayed via pop-up screens. If this occurs, check settings in the Public LAN Configuration screen.

Warning Message	Check Public LAN DHCP Settings
Start Address is not part of the Subnet	Check the value in the DHCP Start Address field
End Address is not part of the Subnet	Check the value in the DHCP End Address field
End Address is below the Start Address	Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds	Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 53	Check the Seconds field at DHCP Lease Time
Minutes must be between 0 and 59	Check the Minutes field at DHCP Lease Time
Hours must be between 0 and 23	Check the Hours field at DHCP Lease Time

If you clicked on OK in the Load new Public LAN configuration? screen, the following pop-up screen will be displayed. This will allow the Router to be reset and the new configuration will take effect. Click on OK.

If you clicked on OK in the preceding screen, the following screen will be displayed. The Router will be reset and the new configuration will take effect.

After a brief delay, the home page will be displayed. Confirm that you have a DSL sync and that your PPP session displays UP. (Click on the connect button to establish a PPP session).

030-300381 Rev. A 79 January 2004