Westell Technologies 7400, 7401 manual Rip

User Guide	UltraLine Home DSL Router (Models 7400, 7401)
Interface	Indicates were to send the packet if it matches this route.
Metric	The RIP metric to be assigned to this route if and when it is advertised using RIP.
RIP	Indicates whether a static route should be advertised via RIP.
	Host Routing Table
Host Routing Table	The list of host routes. A host route is an IP route with a 32-bit mask, indicating a
	single destination (as opposed to a subnet, which could match several destinations.)
Destination Address	The IP address or subnet of the Route.
Netmask	If the Route is a network route, netmask is used to specify the subnet mask.
	If the Route is a Host route, then the Host Route check box is used.
Gateway	Indicates were to send the packet if it matches this route.
Interface	Indicates were to send the packet if it matches this route.
Metric	The RIP metric to be assigned to this route if and when it is advertised using RIP.
RIP	Indicates whether a static route should be advertised via RIP.
	Inactive Routes
Inactive Routes	Static routes whose interface is currently not in service.
Destination Address	The IP address or subnet of the Route.
Netmask	If the Route is a network route, netmask is used to specify the subnet mask.
	If the Route is a Host route, then the Host Route check box is used.
Gateway	Indicates were to send the packet if it matches this route.
Interface	Indicates were to send the packet if it matches this route.
Metric	The RIP metric to be assigned to this route if and when it is advertised using RIP.
RIP	Indicates whether a static route should be advertised via RIP.
	Add Route
Add Route	This is used to add a new static route in the Router.
Destination Address	The IP address or subnet of the Route.
Netmask/ Host Route	If the Route is a network route, netmask is used to specify the subnet mask.
	If the Route is a Host route, then the Host Route check box is used.
Gateway/IP Address	The interface to use for sending the packet, if it matches this route. (Only active
	gateways can be used to create a static route.)
Metric	The RIP metric to be assigned to this route if and when it is advertised using RIP.
RIP Conf	Determines whether or not to advertise the static route, using RIP. (RIP must also be
	enabled before the route will be advertised.)
Save to Modem	If checked, then the route will be made permanent by saving it to flash memory. If
	not checked, the route will disappear the next time the Router restarts.

030-300381 Rev. A 97 January 2004