Wolf Appliance Company ICBMW30-230 TMAPTA004URR0, Microwave can be fitted in position A, B or C

W O L F C O N V E C T I O N M I C R O W A V E I N S TA L L AT I O N

I N S TA L L I N G T H E M I C R O W A V E

1)	Remove all packaging and check carefully
	for any signs of damage.
2)	If the microwave is fitted in position C,
	ensure that the minimum air gaps are main-
	tained as shown in the diagram.
3)	Secure four cupboard retention blocks in
	position using the setting template
	(TMAPTA004URR0).
4)	Fit the appliance into the kitchen cupboard,
	lift over the bottom/front blocks then push
	slowly, and without force, until the front
	frame of the oven seals against the front
	opening of the cupboard.
5)	Ensure the appliance is stable and not
	leaning.
6)	Fix the oven in position with the screws
	provided. The fixing points are located
	within the louvre areas at the top and

	min. 20 mm
Position A	mm
	450
Conventional
oven

min. 20 mm

Position B	mm
	450

5 mm	65 mm
		mm
	Position C	450
		20 mm

	bottom of the oven (see illustration on
	page 13).
7)	Fit the frame fastner caps to the four fixing
	positions (2 spare caps are provided).
8)	It is important to ensure that the installation
	of this product conforms to the instructions
	in this operation manual and the conven-
	tional oven or hob manufacturer’s installa-
	tion instructions.

	Niche Size	Chimney	Gap Between
Position	W x D x H	(min)	Cupboard & Ceiling
A	730 x 610 x 450	20	50
B	730 x 610 x 450	20	50
C	730 x 610 x 450	20	Not Applicable

Measurements in millimeters

	Chimney
	Cable clip	Chimney
Position A		Cable clip
		Position B

Conventional	Position C
oven

The microwave can be fitted in position A, B or C

17