Xerox FS-C8008N, FS-C8008DN manual Using Proof-and-Hold, Deleting a Quick Copy Job, 3-23

Follow steps 1 through 8 in the above section to let the title of the job to be deleted displayed.

3.4 e-MPS

Deleting a Quick Copy Job

All quick copy jobs are automatically deleted when the printer is turned off. If you desire to explicitly delete a stored quick copy job, proceed as follows:

1

2 When the title of the job to be deleted is displayed, e.g. Report, below, press the ENTER key. The cursor below the copy count starts to blink.

>Report

Copies 001

3 Press the V key repeatedly until Delete appears below the title.

>Report Delete

4 Press the ENTER key. The stored quick copy job is deleted.

3.4.2Using Proof-and-Hold

When you print multiple copies, this mode first prints one copy so that you can proof it before continuing to print the remaining copies. Since you can proof the printouts before printing the remaining copies, wastage of paper can be reduced.

The printer prints one copy and, at the same time, saves the print job on the hard disk/RAM disk. You can also change the number of copies when resuming printing from the operator panel.

When the printer is turned off, all stored jobs will be deleted.

Printing Remaining Copies of a Proof and Hold Job

Printing a Proof-and-Hold job on the operator panel is similar to printing a quick copy job.

See Printing Additional Copies using Quick Copy on page Chapter 3-22.

3-23