Xerox FS-C8008N, FS-C8008DN manual Changing Network Interface Parameters, 3-37

3.5 Changing the Interface Parameters

3.5.3Changing Network Interface Parameters

This printer supports TCP/IP, NetWare and EtherTalk protocols. In addition, you can install the optional network interface card in the printer’s extension slot (OPT).

Using the operator panel, you can:

•Activate or deactivate TCP/IP, NetWare, and AppleTalk

•Activate or deactivate DHCP

•Enter IP address, subnet mask address, and default gateway address

•Determine whether to print a network status page when the printer is turned on

To confirm or change network card parameters, proceed as follows:

1

2

3

Press the MENU key.

Press the U or V key repeatedly until Interface > appears.

If the current interface is other than network, press the ENTER key. A blinking question mark (?) appears.

	Interface	>
? Parallel

If the optional network interface card is installed in the printer, Option will be displayed. The setting procedure is basically the same even in this case.

4	Press the U or V key repeatedly until Network appears.
			Interface	>
		? Network
5	Press the ENTER key again.

3-37