Xerox FS-C8008DN press the U or V key to change from Off to On, and press the ENTER key, 3-38

3.5 Changing the Interface Parameters

6	Press the Z key. One of the following menus is indicated. To change settings for the
	item, press the ENTER key. Use the U or V key to change the value or selection.

>NetWare	>
On
>TCP/IP	>
On

>EtherTalk Off

>Network Status Page Off

Range

Set this item to On when you connect to a network using NetWare. In submenu (>), frame mode can be selected from Auto, 802.3, Ethernet II, 802.2, and 802.3SNAP.

Set this item to On when you connect to a network using TCP/IP. Submenu (>) has items including DHCP, IP address, subnet mask address, and gate- way address. To resolve IP address for the network card, see 3.5.4 Resolving IP Address below.

EtherTalk must be activated (On) for networking with Macintosh computers.

When the item is set to On, the printer prints out a net- work status page when it prints the printer status. See Printing a Network Interface Status Page on page 3-40.

7	Activate the appropriate protocol that is required to connect the printer to the
	network. To activate a protocol, let the protocol displayed, press the ENTER key,
	press the U or V key to change from Off to On, and press the ENTER key.
8	Press the MENU key. The display returns to Ready. You can print a network status
	page to confirm that the IP address, subnet mask address, and the gateway address

have been properly set. To print a network status page, see Printing a Network Interface Status Page on page 3-40which follows.

3-38