Xerox FS-C8008N, FS-C8008DN manual Message, Corrective Action, on page, 3 Continued

4.3 Error Messages

Message Corrective Action

Close stacker cover

The optional bulk stacker (ST-30) cover is open. Close the cover.

Duplex disabled	You attempted to print with a paper size and paper type that cannot be used
	for duplex printing. Press the GO key to print onto one-side of the paper
Press GO
	only.
	The duplex drawer is not installed. Install the duplex drawer. This message
Duplex drawer
	is applicable to the DN model.
not loaded

Face-down tray paper full

The face-down tray has become full (approx. 500 pages). You must remove all printed pages from the face-down tray. When the printer detects that the face-down tray is empty again, the printer will continues printing into the face-down tray.

Face-up tray path error

The face-up tray is not open although you have attempted to print in the face-up tray. Open the face-up tray.

File not found Press GO

You have attempted to print a job that is not contained in the specified virtual mailbox, or the specified virtual mailbox is not found.

If Auto Continue is set to On, printing will be automatically resumed after a preset period of time. For details on Auto Continue, refer to Chapter 3 Using the Operator Panel.

Finisher tray ## paper full

The optional document finisher (DF-31) tray is full. Remove all printed pages from the tray.

Finisher	The optional document finisher (DF-31) is not installed properly. Correct
	the installation, by referring to the instructions supplied with the document
path error
	finisher.
	The memory card inserted in the printer is not formatted, and therefore can-
Format error
	not be read or written. To format a memory card, follow the procedure in
Memory Card
	Chapter 3 Using the Operator Panel, section Formatting a Memory Card
	on page 3-64.
	The hard disk installed in the printer is not formatted, and therefore cannot
Format error
	be read or written. To format the hard disk, follow the procedure in the
Hard disk
	Installation Guide of the hard disk.

Hard disk err ##	A hard disk error has occurred. Look at the error code given in place of ##
Press GO	and refer to Storage Error Codes on page 4-11. To ignore the hard disk error,
	press the GO key.

I/F occupied

This message is displayed when you attempt to use the printer’s operator panel to change the environmental settings on the interface from which data are presently being received.

ID error

The user ID entered for a private job, or a stored job is not correct. Check the user ID that you specified on the printer driver.

Incorrect slot Please reinstall

The optional hard disk is installed in the network interface card slot (OPT) in the printer.

The optional network interface card is installed in the hard disk slot (HDD) in the printer.

Install it in the appropriate slot.

Table 4-3 (Continued)

4-7