Using NetWare Utilities
Installation Procedure
There are three stages required to install the WorkCentre PE120i on a NetWare network using NetWare utilities:
¾Network Communication Setup
This procedure will enable the WorkCentre PE120i to communicate on the
NetWare network.
¾NetWare Setup
This procedure is used to setup the network using NetWare utilities, for example NWADMIN.
¾Test Print
A print job should be submitted to ensure the WorkCentre PE120i has been installed and configured correctly.
If running NLSP, ensure that RIP/SAP compatibility is configured on the same segment as the
WorkCentre PE120i.
Network Communication Setup
At the WorkCentre PE120i, perform these steps:
HINT: Xerox CentreWare Internet Services can also be used to configure the WorkCentre PE120i, refer to the Internet Services chapter for instructions.
¾Ensure that the Basic TCP/IP settings have been configured (see “Network
1 | Communication Setup” on page |
|
2 | ¾ Press [Menu] until you see |
|
| Network Setup on the top line of |
|
| the display. |
|
| 8. Network Setup | |
|
|
[Reset Network]
NetWare
Xerox WorkCentre PE120i System Administration Guide | Page |
