Xerox PE120i manual Network Setup Config Network Ethertalk

AppleTalk

3

4

5

¾Press or until Configure Network is displayed and press [Enter].

¾Press or until Configure Network is displayed and press [Enter].

¾Press or until Ethertalk is displayed and press [Enter].

¾To enable or disable Ethertalk,

press or until the desired setting, [On] or [Off] is displayed and press [Enter].

8.Network Setup [Config Network]

Config Network

[Ethertalk]

Ethertalk

[On]

NOTE: The WorkCentre PE120i will attach itself to the default zone of the local segment where it is connected.

6 ¾ Install the Printer Driver (see “Printer Driver Installation (Mac OS 8x,9x only)” on page 5-5).

Page 5-4 Xerox WorkCentre PE120i System Administration Guide