Network Installation Using Internet Services

AppleTalk

Use these instructions to install the WorkCentre PE120i on an AppleTalk network using CentreWare Internet Services.

Installation Procedure

There are two stages required to install the device on an AppleTalk network using CentreWare Internet Services:

¾Configure the WorkCentre PE120i

This procedure explains how to use CentreWare Internet Services to configure the device.

¾Test Print

A print job should be submitted to ensure the device has been installed and configured correctly.

Configure the WorkCentre PE120i

To complete the installation of the WorkCentre PE120i, perform these steps:

1

¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 6-5).

¾At the CentreWare Internet Services Home Page for the WorkCentre PE120i, select the

2

[Properties] tab.

¾Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,

4

and then select the [+] symbol to the left of the Protocols folder.

5

¾ In the Properties frame, within the Protocols folder, select [AppleTalk].

6

¾ Make the following selections and settings in the AppleTalk Physical Configuration section

of the Protocols frame:

Select the checkbox to enable AppleTalk.

Enter the [Printer Name]. Use a meaningful name, such as the location of the device.

Choose the Zone where the printer resides from the drop-down list.

7

¾ Click the [Apply] button to implement any changes.

Page 6-8

Xerox WorkCentre PE120i System Administration Guide

Page 74
Image 74
Xerox manual AppleTalk, Configure the WorkCentre PE120i